sealing sinew on arrows?

[Aaron H]

Do you guys normally seal your sinew when wrapping fletchings and hafting points to your arrow shafts? 

[Trapper Rob]

I use pitch varnish to seal mine the last one I didn't & it started to UN wrap at the nock after a few shots.

[Pat B]

I use pitch varnish also. I have used TBIII, Duco cement and super glue. All worked well.

[Aaron H]

I have used super glue in the past, I just don't like the glossy appearance it gives it.

[Pappy]

I use Tru oil or most of the time TB3. 
  Pappy

[Ed Brooks]

I pull the end under the wrap before it pull tight cut it off and leave it. no sealer on the sinew. Ed

[RBLusthaus]

I use cheap clear nail polish.  Brush in the jar. 

[wizardgoat]

I've been using slightly watered down TB3 painted on with a brush

[PeteC]

I use TB3 as well,applied with a damp brush.3 coats,let cure,then wet sand.apply glue,(and sand), until it it a perfectly smooth transition between head,sinew,and arrow. Sinew is waterproofed,and excellent arrow penetration. MHO  God bless

[Aaron H]

I tried using tb3 and I prefer it over the super glue, it has less of a glossy sheen.  Thanks everyone

[nclonghunter]

Last ones I made the sinew strips were put in some warm hide glue before wrapping. Once wrapped and set I smeared just hide glue around the outside and it was a good protection. Heat and water will soften the hide glue, not certain how long it would take with only water.

[mullet]

I soak my sinew in a bowl of watered down TB3.

[chamookman]

For Arra wrapping, I'd always just chew the piece of Sinew for a minute before wrapping. TB lll was used to seal. Bob

[JEB]

I use  epoxy.  I take my finger and tamp the glued area a few times and it dulls the glossy finish.

[beartail]

hay mullet! I do the same thing.i soak mine in waterproof glue then wrap.