« previous next »
Pages: [1]

Author Topic: Measuring tiller  (Read 1487 times)

0 Members and 1 Guest are viewing this topic.

Offline TimothyR

  • Member
  • Posts: 658
  • PM110782
Measuring tiller
« on: July 13, 2019, 07:13:23 pm »
Anyone on here ever use a carpenter's square to measure tiller?
Logged
Freedom dies one compromise at a time. III%

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: Measuring tiller
« Reply #1 on: July 13, 2019, 07:57:15 pm »
I've never tried it but haven't needed to. If it works you then that's all that matters.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline SLIMBOB

  • Member
  • Posts: 3,759
  • Deplorable Slim
Re: Measuring tiller
« Reply #2 on: July 14, 2019, 05:38:53 am »
I have used a framing square in various ways.  Getting good brace profile mostly.
Logged
Liberty, In God We Trust, E Pluribus Unum.  Distinctly American Values.

Offline Eric Krewson

  • Member
  • Posts: 5,432
Re: Measuring tiller
« Reply #3 on: July 14, 2019, 05:39:33 am »
I use a gizmo to tiller limbs so I know the limbs are bending correctly. The only measurement I take is to measure the distance from the string to the belly 12" in from the tips on both limbs. Shooting split finger I need the top limb to be slightly positive, usually 3/16", this measurement tells me how far I am off and which limb to adjust.
Logged

Offline bushboy

  • Member
  • Posts: 2,256
Re: Measuring tiller
« Reply #4 on: July 14, 2019, 05:36:00 pm »
When I made alot of board bows ,yes I would measure height distances to compare at brace.
Logged
Some like motorboats,I like kayaks,some like guns,I like bows,but not the wheelie type.
Pages: [1]
« previous next »