Greetings folks, awhile back I built a bamboo backed yew warbow that pulls 110@28" , in order to shoot it and finish her up(sanding, finishing the nocks and strike plate shes ready to go) I need the bow strength to shoot it so i built this warbow off the same piece of lumber although this one is full of knots to build strength. It's got 1/8 hickory backed, 72" ntn, 31mm wide for a good section of the center then tapering to the 12mm buffalo horn tips, more so the last 10 ". 24mm thick at the handle and out 10" either side of the handle, then tapering to the tips. The strike plate is mother of pearl that I got from Upstatenybowyer, thanks Jeff. Its finished in tounge oil. 20 strands of D-97 string so there is zero stretch. I'm surprised that it has held together with the all the knots, goes to show how tough yew is. I've put 200 arrows through it and its as sweet a bow I have ever shot although I struggle to get to 28.
The arrows are 3/8 poplar dowels with 7 " turkey feathers that i wrapped with upholstery thread and coated with TB3 the nocks are reinforced with 1/16 phenolic because I had some. I forged those bodkins out of 5/16 steel rod. I have'nt shot them yet, I'm still finishing the other 3. I will report back after testing them out in a field. Thanks for looking, Bob