Favorite tooth count and width bandsaw blade?

[Auggie]

 Was wondering what blades you guys have tried,and like the most.

[Justin Snyder]

3/4 inch 6 tooth hook.

[Stretch]

This depends a lot on your bandsaw.  Most small saws can't adequately tension a 3/4" blade even if they have the capacity to run one.  For general work I like a 3/8" 6 tpi.  For heavy duty resawing or log cutting I run a carbide tipped 5/8" 3 tpi blade.  It's about all my 15" saw can adequately tension.  One day, I will have a 19" saw, and a 1" 1.3 tpi Lennox carbide blade will live on that thing.  My little saw will be reserved for scrolling and light duty work. 

[osage outlaw]

Like stretch said, it depends on the size of your saw.

I have a 12" Craftsman and I use a 1/2" blade 6 tpi because that is what I can buy at our local Lowes store. 

[Pappy]

I use the same as Justin on my 2 big saws 14 inch and smaller finer blades on my smaller ones, I have 3 12 inch that I keep an assortment of blades on so I don't have to change blades ,depending on what I cut, Remember narrower blades make turns better,for straight line rough cuts the wider the better.
   Pappy

[Badger]

   I have the 14" delta and usually run the 1/2" X 4tpi. I have a 3 tpi on it right now but it feels a bit rough when cutting.