Author Topic: Tillering Question  (Read 1447 times)

0 Members and 1 Guest are viewing this topic.

Offline Bevan R.

  • Member
  • Posts: 1,691
Tillering Question
« on: November 17, 2010, 03:24:56 pm »
I remember reading something recently that said if the limbs of the bow are the same length that you need to tiller the upper limb to bend 3/8 inch more that the bottom limb. Do I have that right? backword? I make bows with the handle centered on the stave/board, with the limbs the same length and the arrow pass/shelf 1 inch above center. I have gone back through what I have been reading lately and can not find it again. ???
Bowmakers are a little bent, but knappers are just plain flaky.

Offline woodstick

  • Member
  • Posts: 899
Re: Tillering Question
« Reply #1 on: November 17, 2010, 06:21:41 pm »
i make mine same length but i go for my arrow shelf 1 1/2 above center. never had trouble out of them
a drawn bow is a stick 9/10 broken

Offline sailordad

  • Member
  • Posts: 5,045
Re: Tillering Question
« Reply #2 on: November 17, 2010, 06:26:52 pm »
most my bows are done with a 4" handle area(2.5"below center,1.5" above center),with the arrow rest about 1.25"over center
i usually try and tiller the lower limb slightly stiffer than the upper,3/8ths should be fine

i always wanted a harley,untill it became the "thing to ride"
i ride because i love to,not to be part of the crowd

Offline George Tsoukalas

  • Member
  • Posts: 9,425
    • Traditional and Primitive Archers
Re: Tillering Question
« Reply #3 on: November 17, 2010, 06:43:51 pm »
That's what I do BUT at full draw. I don't care what it is doing at brace height. Jawge
Set Happens!
If you ain't breakin' you ain't makin!

Offline sailordad

  • Member
  • Posts: 5,045
Re: Tillering Question
« Reply #4 on: November 17, 2010, 07:06:57 pm »
George,your right.as usual  ;)
i should have mentioned that it should be at full draw  ;D
i always wanted a harley,untill it became the "thing to ride"
i ride because i love to,not to be part of the crowd