Fletch Tite on Non Bohning Sealers

[Stonedog]

So, I am no longer buying the Bohning sealers.  I am too poor and they are too expensive for me to keep using.

So, I do have a crap ton of Fletch Tite though and would like to use it.

Does anyone know of a store bought sealer that will work with Fletch Tite?

[half eye]

stonedog,
        I had some of the same problems....solved them differently by dumping the bohnings and went with duco cement. A little trick you can try though is crest dip the shaft with regular lacquer, let it dry well, then rub the snot out of it with a kids eraser.....the pink kind thats like a square. What that does is give the surface "tooth" (means stuff will stick to it) Works good enough that ya can paint water based acrylics onto the lacquer and it will bond......that might get a good joint with the bohnings. Not much help but it just might let ya use up that "fletch-tite".       One other thing is to rub the lacquer down with some 600 wet/dry sandpaper (ya dont want to take the lacquer off....just make it look dull.
rich

[mullet]

 I use Loc-Tite Super Gel glue.

[NorthernArcher]

I have used both Fletch Tite and Duco Cement in the past, and never with a Bohning finish.  My preferred finish was water-based Varathane, and both glues stuck to it just fine.  Roughing up the surface before applying the glue is always a good idea if you choose to use the high gloss finish.  I preferred the low gloss, as it dried with a rougher texture and didn't shine at all, and I didn't have to rough up the surface before fletching.  Hope this helps.