« previous next »
Pages: [1]

Author Topic: Am I Fail?  (Read 1647 times)

0 Members and 1 Guest are viewing this topic.

Offline Aries

  • Member
  • Posts: 493
Am I Fail?
« on: April 13, 2010, 10:55:27 pm »
Here is a pick of a bow limb i was heat treating, Im pretty sure i ruined it, but was hoping i could salvage the limb by sanding off the damaged area. I left this section of the limb unattended for 5 minutes while it cooked under the heat gun suspended 5" away. the limb thickness is just over 1/4 in at the area of the damage. it appears that bubbles formed on the back of the pow and subsequently "popped". I  had plans on bamboo backing this after completing the heat treating process.  Here is the pick.

[attachment deleted by admin]
« Last Edit: April 13, 2010, 11:02:33 pm by Aries »
Logged
"If the only tool you have is a hammer,
                   you tend to see every problem as a nail."
                               ~Abraham Maslow

Offline Aries

  • Member
  • Posts: 493
Re: Am I Fail?
« Reply #1 on: April 13, 2010, 11:10:46 pm »
the damage is nine inches from the tip on the back of the bow

[attachment deleted by admin]
« Last Edit: April 13, 2010, 11:14:10 pm by Aries »
Logged
"If the only tool you have is a hammer,
                   you tend to see every problem as a nail."
                               ~Abraham Maslow

Offline Jmilbrandt

  • Member
  • Posts: 363
Re: Am I Fail?
« Reply #2 on: April 13, 2010, 11:28:43 pm »
It looks to me like you heated to fast while it was too moist. That's the only time I have ever had that happen anyway. I think it will be ok if you sand it down and back it though.
Logged
SW Utah

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: Am I Fail?
« Reply #3 on: April 13, 2010, 11:50:44 pm »
Did the heat from the gun wrap around the stave to scorch the back or were you heating the back?
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline Aries

  • Member
  • Posts: 493
Re: Am I Fail?
« Reply #4 on: April 14, 2010, 10:37:53 am »
Pat the heat wrapped around i presume, i was  heating the limb only from the belly side.
Logged
"If the only tool you have is a hammer,
                   you tend to see every problem as a nail."
                               ~Abraham Maslow

Cacatch

  • Guest
Re: Am I Fail?
« Reply #5 on: April 14, 2010, 12:18:06 pm »
You didn't ruin it. I'd say the biggest problem you'll have now is that when you begin to tiller the bow, you'll find that spot to be stiffer than the rest of the bow. And you'll have to either make it thinner in that spot (which I wouldn't recommend) or heat treat the other limb the same way to make it symmetrical, and possibly all working parts of the bow. That looks like osage to me, and it's not finished yet, so I think you can still finish it and back it, no problem.
Logged
Pages: [1]
« previous next »