« previous next »
Pages: [1]

Author Topic: Bug hole help  (Read 883 times)

0 Members and 1 Guest are viewing this topic.

Offline Freeflynick

  • Member
  • Posts: 32
Bug hole help
« on: June 13, 2020, 04:38:10 pm »
Hello,
I have a decent looking piece of ipe that I was going to add a hickory backing to for a flatbow design. Then I found this bug hole (see photo). It is a little over 1/32" wide, and about 1/2" deep. The ipe board is 3/4" thick and 1.5" wide.
What is my best option here? I would think putting it on the belly would be the best, but wanted to get your thoughts.
Thanks again guys!
Nick
Logged

Offline Hamish

  • Member
  • Posts: 1,557
Re: Bug hole help
« Reply #1 on: June 13, 2020, 04:54:22 pm »
Whittle a thin dowel from a scrap of ipe, and glue it in with a slow set epoxy, or urac. Flush it off with a chisel and back it with hickory
Logged

Offline Freeflynick

  • Member
  • Posts: 32
Re: Bug hole help
« Reply #2 on: June 14, 2020, 05:44:27 pm »
So you suggest putting it on the back, rather than on the belly where a lot of it will be tillered off? What the thinking behind that?
Logged

Offline bassman

  • Member
  • Posts: 962
Re: Bug hole help
« Reply #3 on: June 15, 2020, 12:07:47 pm »
With his suggestion he is making a solid repair on the bug hole, and then covering with Hickory which should work just fine. I have made a lot of successful repairs on the belly of bows with crazy glue ,and in your case Ipe saw dust. I fill the hole up with red bottled super glue ,and pack the hole tight as you go ,and add a little glue . Pack it past flush,and then sand down. Either way it should be fine.JMO
Logged
Pages: [1]
« previous next »