« previous next »
Pages: [1]

Author Topic: It's a Rhyolite something!  (Read 7177 times)

0 Members and 1 Guest are viewing this topic.

Offline nclonghunter

  • Member
  • Posts: 1,779
It's a Rhyolite something!
« on: January 17, 2017, 02:29:06 pm »
Lost about 1/2 inch on length and 3 inches on width. This rock is hard to get wide and thin. I suppose it could be a knife or a Rhyolite version of a danish dagger...:-)
Logged
There are no bad knappers, only bad flakes

Offline bjrogg

  • Member
  • Posts: 11,016
  • Cedar Pond
Re: It's a Rhyolite something!
« Reply #1 on: January 17, 2017, 03:10:11 pm »
If I was working it I'd end up with it broken and then it'd be two knives. Of course the big problem would be one short one and one long one cause I'm sure it wouldn't break in the middle on me.lol. Nice work there NC looks impressive to me. Bjrogg
Logged
A hot cup of coffee and a beautiful sunrise

Offline Outbackbob48

  • Member
  • Posts: 2,752
Re: It's a Rhyolite something!
« Reply #2 on: January 17, 2017, 03:38:06 pm »
Lyman, looks like you got a real handle on the rhyolite. As for the strength of rhyolite knives ask James Parker about how strong they are against trees in the wee hours, I'll let him tell ya story.  ;D Bob
Logged

Offline nclonghunter

  • Member
  • Posts: 1,779
Re: It's a Rhyolite something!
« Reply #3 on: January 17, 2017, 09:06:26 pm »
Bob, sounds like it will be a good story... ;D

Measured the thing and it is 7 1/2 inches. I made a few more edge flake removals and still didn't break it. Must have been living right today.. :)
Logged
There are no bad knappers, only bad flakes

Offline Hawkdancer

  • Member
  • Posts: 5,040
Re: It's a Rhyolite something!
« Reply #4 on: January 18, 2017, 12:55:31 am »
Looks like it needs an antler haft!  May not be a good throwing knife.  Real nice work
Hawkdancer
Logged
Life is far too serious to be taken that way!
Jerry
Pages: [1]
« previous next »