Author Topic: Patterned burlap backed red oak in progress. Advise needed (pics) (Read 1423 times)

make-n-break · « **on:** July 12, 2015, 01:30:09 am »

Here's one that's been in progress for a few days. I originally combed out a pile of 12" sisal fibers and backed it with two layers, but after 48+ hours it was still gooey. Guess I put too much on at once. Anyway, stripped that off and made a trip to the fabric store for some jute. Found some burlap with a pattern that seemed like it would be well concealed in the woods.

I backed it for extra assurance because the grain is a little wonky near the handle. Real good grain on the limbs tho, one run out per. I really want this one to survive so I can shoot it at Marshall next week. I've never been so careful with one up to this point lol. I've given it 100% effort the whole way.

Its 68 ttt and 1.75" wide at the fades with a 4" narrow and deep stiff handle and 2.5" fades. Question is, you guys think this design will hold up to 50@27"? I've always trusted hickory lumber, but the few times I've went for it with red oak I ask too much of my designs and get frets. Long string tiller starts tomorrow. I plan on trapping the back a little too.

make-n-break · « **Reply #1 on:** July 12, 2015, 01:34:40 am »

I'd go down in weight if anyone thinks that's a good idea. Want a hunting weight bow though! Was hoping #45+

bubby · « **Reply #2 on:** July 12, 2015, 01:47:25 am »

Y i u can get a hunting weight bow from red oak no problem

Dakota Kid · « **Reply #3 on:** July 12, 2015, 02:28:34 pm »

I probably would have glued a thin overlay(wood/bone/ antler) on the back of the handle section if it was an area of concern. You could still do it if you built up a layer of TB in the handle and sanded it flat. Just keep it thin or it will pop off.