« previous next »
Pages: 1 [2]

Author Topic: Bending ERC  (Read 2128 times)

0 Members and 1 Guest are viewing this topic.

Offline bubby

  • Member
  • Posts: 11,054
Re: Bending ERC
« Reply #15 on: April 19, 2013, 05:38:41 pm »
Pat I saw a guy on youtube bend a pc about 3/8" or 1/2" thick in what looked like a 12" radius, shocked the heck out of me, that's why I tried it
Logged
failure is an option, everyone fails, it's how you handle it that matters.
The few the proud the 27🏹

Offline vinemaplebows

  • Member
  • Posts: 1,419
Re: Bending ERC
« Reply #16 on: April 19, 2013, 06:12:21 pm »
I have been doing this for yrs., and yes I have holes in it! :laugh: If you are afraid of microwaves then why would you eat food that comes out of it is my question. ;) If you put wet rags in the holes around your stave little of the microwaves escape....the rags will ge hot on the inside, but not the outside. :) I have been using this method since that PA article was written.

VMB


« Last Edit: April 19, 2013, 06:17:07 pm by vinemaplebows »
Logged
Debating is an intellectual exchange of differing views...with no winners.

Offline bubby

  • Member
  • Posts: 11,054
Re: Bending ERC
« Reply #17 on: April 19, 2013, 06:39:52 pm »
so you put the holes in the door and back? i'd have thought the sides, nice draw knife
Logged
failure is an option, everyone fails, it's how you handle it that matters.
The few the proud the 27🏹

Offline vinemaplebows

  • Member
  • Posts: 1,419
Re: Bending ERC
« Reply #18 on: April 19, 2013, 06:53:53 pm »
Yes, don't cut side to side! I found that little drawknife in a tool box at a swap meet....(the metal only) I added the ocean spray handles. It is very small, but is my favorite drawknife. Pays to dig sometimes! ;)

VMB
Logged
Debating is an intellectual exchange of differing views...with no winners.
Pages: 1 [2]
« previous next »