RED OAK BACKING

[L33Twolf90]

hello everyone, i just recently made a red oak flat bow and when i was sanding it to apply a finish i noticed a small
line along the edge of the the back which seems to be a small splinter. during tillering it never showed up, till now. so to help prevent that splinter from rising or creating a problem i added a simple "brown paper" backing applied with some titebond. Was this a good aid and can i add a reflex to the bow. Any feedback would really help out. thanks.

[lostarrow]

Any heating should be done before gluing on any backings as most glue is heat sensitive and likely to fail. Adding reflex to an already comprimised bow would only make the problem worse . You would be adding more stress to the limbs to even get it braced. If your backing holds , enjoy your bow ,. If it doesn't , make another and learn from your last. I suspect you were planing on doing that anyway.

[L33Twolf90]

the backing held find and thanks for the tip lostarrow. its shoots really good also. i did notice a slight decrease in arrow speed after the backing dried. and i definately plan on making more. this was my second attempt at a bow and first success. im completely hooked =D

[adb]

Be sure to round off all your edges. A sharp edge will likely result in a problem like yours.

[lostarrow]

Lots of help here to get you going! congrats on your first shooter.

[L33Twolf90]

thanks again. this really helps. i cant stop shooting. now i want to go out and start hunting.