« previous next »
Pages: [1]

Author Topic: Elm sapling  (Read 1568 times)

0 Members and 1 Guest are viewing this topic.

Offline JMcCauley

  • Member
  • Posts: 16
Elm sapling
« on: November 02, 2011, 08:47:12 pm »
I cut an elm sapling, or small tree (it's relatively large). It is mostly defect free except for a sort of hump on one side about 18 inches from the base, the other side will work though I think. So... This being my first attempt at something like this I need to know if I should season it at all, should I strip the bark? I don't know any of this yet, so please be specific with the advice. Thanks  :).
Logged

Offline George Tsoukalas

  • Member
  • Posts: 9,425
    • Traditional and Primitive Archers
Re: Elm sapling
« Reply #1 on: November 02, 2011, 09:04:12 pm »
My first shooter was made from a sapling bow. Pick out the best side for the back. Mark 2 magic marker lines to delineate back from front. Remove the belly wood with a hatchet.Remove the bark and tiller the bow. See Bowmaking Directions on my site. Leave the stave a few inches longer than usual for you. You can get the limbs bending a few inches. It will dry faster. Jawge
http://georgeandjoni.home.comcast.net/~georgeandjoni/
Logged
Set Happens!
If you ain't breakin' you ain't makin!

Offline Josh B

  • Member
  • Posts: 3,741
Re: Elm sapling
« Reply #2 on: November 02, 2011, 09:22:23 pm »
If you are going to thin it to dry faster,  make sure to tie it down to something to keep it straight.  Elm has a very nasty habit of warping and twisting while drying.  More so than any other wood i've used.    Josh
Logged
Pages: [1]
« previous next »