Trade bow tiller check

[tetaxidermy]

Here is a bow been working on, possible trade bow we'll see. See what you guys think of the tiller, it is close too draw weight and length. Hackberry, 59'' ntn draws 50# at 24'' right now. veiwed from either sidebracedveiw of the back.

[bubby]

in the first pic the limb on the left looks a little stiff outta the fades, but might just be the angle,jmho, brace and front profile look great, did ya flip the first two pics, anyhow it's looking great,love the back,  Bub

[crooketarrow]

   LOOKS THE SME TO ME.

[tetaxidermy]

The first two pics are one of each side.

[George Tsoukalas]

She looks good but if you need more draw  length you'll have to get the near andle wood moving more. She's a it on the short side for more than 24" for a rigid handle bow. Jawge

[Elktracker]

I agree with bubby but all in all its looking great to me! keep up the good work!

Josh

[adb]

Looks good to me. How much set has it taken?

[Mangeur de lard]

Nice bow! Quite the bend too! It does look like one limb bends a bit more in the inner third, not much tough.
Cheers!

[tetaxidermy]

Not to much set I don't think, but hard to tell, one limb is slightly reflexed and one is slightly deflexed a little heat treating should cure that, we will see. Thanks for the input, going to do a bit more scraping and put some arrows through it.

[Pappy]

Looks pretty good,I would say a little more out of the fads and outer 1/3 if you have weight and drawlength to give. Lots of bend for a shot bow. What draw length are you looking for ?
   Pappy

[tetaxidermy]

Thanks Pappy can't say to much about draw length, don't want to give any hints to who it's for. It is close, got some wiggle room yet.

[DEllis]

I agree with Pappy about the outer thirds and fades. You'll need to use all the limb you can at that length with a stiff handle. It does look nice though and you are very close in my opinion Carefull with the fades as you'll loose weight fast if you scrape much there.
Darcy