« previous next »
Pages: [1]

Author Topic: Steaming tempered wood?  (Read 1921 times)

0 Members and 1 Guest are viewing this topic.

Offline Kegan

  • Member
  • Posts: 2,676
Steaming tempered wood?
« on: July 29, 2010, 01:20:07 pm »
I'm working on a couple takedowns with wrapped steel sleeves. So far it's working fine. The first bow took 1" of set (started straight) which I was pretty happy about, but there's also 1" of give in the handle. So at the moment it has 2" of string follow. I already temepered the belly, but is it possible to steam the tips into a little reflex? The cast is only fair, and I'm not too happy about the 2" of string follow.

Thoughts?
Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: Steaming tempered wood?
« Reply #1 on: July 29, 2010, 04:02:53 pm »
I think I would seal the tips with shellac before steaming to prevent possible checking. Other than that there should be no problem.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline Justin Snyder

  • Administrator
  • Member
  • Posts: 13,794
Re: Steaming tempered wood?
« Reply #2 on: July 29, 2010, 05:48:16 pm »
If it has been tempered, I would use dry heat not steam. If all you are after is a little reflex dry heat should be fine.
Logged
Everything happens for a reason, sometimes the reason is you made a bad decision.


SW Utah
Pages: [1]
« previous next »