« previous next »
Pages: 1 2 [3]

Author Topic: "Two Tips" (not for BOM)  (Read 6974 times)

0 Members and 1 Guest are viewing this topic.

Offline TBod

  • Member
  • Posts: 275
Re: "Two Tips" (not for BOM)
« Reply #30 on: July 13, 2010, 04:08:12 pm »
Very nice!

Not sure I understand it correct. Did you glue on a thin piece of Osage from the fades to about 2/3 of the limb belly side? Not on the handle right because of the taper in thickness at the fades?
Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: "Two Tips" (not for BOM)
« Reply #31 on: July 13, 2010, 04:48:27 pm »
TBod, The Argentine osage slats I added to the belly butts together at the handle and ran to the recurves until I re-tillered the bow. I added a thin piece of ERC over that joint to secure it and to pack out the handle a bit on the belly. I used leather to pack out on the back. You can see the ERC sticking out from under the handle wrap on the belly. This bow bends in the handle at full draw.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline n2huntn

  • Member
  • Posts: 468
  • jeff_smith13@hotmail.com ROLL TIDE !
Re: "Two Tips" (not for BOM)
« Reply #32 on: July 13, 2010, 05:52:14 pm »
Very good looking weapon, I hope it makes a lot of meat for you.
Jeff
Logged
Genesis 27: 3

Offline TBod

  • Member
  • Posts: 275
Re: "Two Tips" (not for BOM)
« Reply #33 on: July 14, 2010, 06:36:56 am »
Ok now I understand, thanks!
Logged
Pages: 1 2 [3]
« previous next »