Primitive Archer
Main Discussion Area => Bows => Topic started by: DC on April 03, 2018, 03:28:46 pm
-
I have a Black Locust stave that Pender Bender gave me. Thanks Brendan. It has very fine rings, about 40 or better rpi. I really doubt that I can chase one 6" let alone 66". Should I just get it as smooth as I can and hope thin rings trumps a few violated ones. I think this grew on Pender Island so it will be different than what you get back east. Same species, different climate.
-
I've worked with Osage that had VERY thin rings like that. If I were you I'd chase one the best I could and then back it with rawhide or cherry bark. :)
-
The only wood that I know of where ring violations are ok is yew.
I do the best I could and then back it with rawhide, linen, silk or burlap.
Jawge
-
Would it stand a thin Maple back?
-
DC, I can't say. I've never done a wooden backing. Jawge
-
Don back it for sure. I just broke the other half of that sapling floor tillering. Some of those rings on the back are questionable. After it broke you could see the sap wood rings were almost rotten. Really tissuey. Haha if that's a word. It broke like a foot from the tip and on the back and then just basically followed that ring right up until it hit a knot and stopped. The heart wood didn't brake at all. Cheers- Brendan
-
I think I'll try my maple backing. I'll go thin and maybe trap the back. There's a knot to deal with too. Ahh, I like a challenge ;D ;D
-
Why specify "thin" maple back? I think a maple back would be fine, of course. Is the locust low-density due to the rings, or normal density and just a lot of rings?
I have backed QS black locust with hickory, bamboo, and white oak with good results. Can't see why maple wouldn't work.
-
I didn't want to overpower the BL belly. The rings that will be the belly look pretty good from an early/late aspect. When I decrown it that will get rid of the really thin rings. I don't have a lot of experience with BL(1 bow) so I'm not really sure of the quality.
-
I have a Black Locust stave that Pender Bender gave me. Thanks Brendan. It has very fine rings, about 40 or better rpi. I really doubt that I can chase one 6" let alone 66". Should I just get it as smooth as I can and hope thin rings trumps a few violated ones. I think this grew on Pender Island so it will be different than what you get back east. Same species, different climate.
Nothing to do with climate, I live south of you a bit, but I have seen half inch rings in locust on the coast and in king county. Matter of fact I know where a whole pile is sitting right now, I will see if I can get a pic.