Primitive Archer

Main Discussion Area => Bows => Topic started by: rocko on March 02, 2008, 08:38:53 pm

Title: Snake skin backing
Post by: rocko on March 02, 2008, 08:38:53 pm

I just finished putting the snake skin on an Osage bow that has a lot of character. My question is what to do with the edges. My original intention was to bring the skin over the edge and trim along the side of the bow, following the contours of the back. But I've been wondering if it would be better to fade the edges in on the back of the bow...not bring them over.
Any thoughts or experiences?

Title: Re: Snake skin backing
Post by: Dano on March 02, 2008, 09:32:14 pm

I always fade the edges, they blend in much better when the finish is applied. I use 220 grit on a rubber sanding block, and just work the edge.

Title: Re: Snake skin backing
Post by: rocko on March 02, 2008, 09:44:49 pm

Perfect! Thanks Dano.
 That's what I was hoping to be able to do, just wanted to hear it from someone else that it would work.

Title: Re: Snake skin backing
Post by: Pappy on March 03, 2008, 08:32:02 am

What Dano said.Letts see some pictures when you are finished. :)
    Pappy

Title: Re: Snake skin backing
Post by: rocko on March 03, 2008, 10:19:42 am

I'll do it!