Primitive Archer
Main Discussion Area => Bows => Topic started by: ajooter on December 20, 2015, 02:44:57 pm
-
I started working on this bow quite awhile ago. It had a nasty grain swirl that chunked out on me when I ran my rasp the wrong way. The area affected was near one of the tips and since I had already shaped the handle out I had to removed about 4" from each tip. The bow is ~60" ttt and pulling 35#@21". I'm gonna try and keep the dw below 40# and get it back to about 24-25". It hasn't taken that much set as of yet. The handle and tips accents are red oak and purpleheart. I thought it would make a nice bow for a woman or child.
Don't be hatin on the pjs....im going for a trip on the polar express train with my gfs 4 year old!
(http://i.imgur.com/6yhFWFD.jpg?1)
(http://i.imgur.com/hjf5LK6.jpg?1)
(http://i.imgur.com/SPiOuIk.jpg?1)
(http://i.imgur.com/MKv0vGR.jpg?1)
(http://i.imgur.com/0AHsvJT.jpg?1)
(http://i.imgur.com/JbinETa.jpg?1)
-
Looks pretty good, I never use a rasp or blade on boards, use belt sander much quicker and remove less material. Ya got a ways to go yet to hit below 40# and get it back to about 24-25".
-
Nice looking bow like the accents , I have fount working with furniture as well as bows Rock Maple can have a lot of tear out if you go against the grain ,I'm working on a maple stave bow now waiting for the sinew to cure & have one spot in the handle that's giving me a little trouble but will take it there instead of the limbs keep us posted curious to see how it works out
-
A belt sander?!?! I couldn't do it! To each his own...I like a hatchet...rasp...and scraper...three tools and I'm pretty much there. Once the handle and tip overlays are glued on I can have a bow to floor tiller in about 2 hours.
-
The limbs are still an inch and a half wide. I also wanted to try and keep that width since im told wider thinner limbs take less set. I made a maple board bow awhile ago that I heated a bunch of reflex into and heat treated the limbs at the same time. That bow was also 60" and came in between 70-75# at 28". I burned around 300 arrows thru it before it blew. This was intended to be a longer bow and since the last one I heat treated responded well to the heat I would probably try the same again on a different bow. So far maple is my favorite wood in board form.
-
A belt sander?!?! I couldn't do it! To each his own...I like a hatchet...rasp...and scraper...three tools and I'm pretty much there. Once the handle and tip overlays are glued on I can have a bow to floor tiller in about 2 hours.
Slow and steady as they say, I check the thickness with the calipers as I go and exercise the bow about 30 pulls everytime. Never had a hinge yet using the sander. :)
-
Sharp looking bow. I like how you added recurves using overlays.
-
Very nicely done. Jawge
-
Thank you guys...I'll post finished pictures when I'm done