Primitive Archer
Main Discussion Area => Bows => Topic started by: Jjpso on June 02, 2014, 06:24:07 pm
-
Hello everybody.
I am doing a red or white oak (not sure wich one is) board bow.
It is 66" tip to tip, whit 4" handle an 2" fades.
The limb width starts at 2 1/4" tappering to 1/2" tip.
I REALLY want it to be a 50-55# bow.
My doubt is about the thickness it should be.
Do you think:
1. I should go for a constant thickness, and if so how much should it be, taking in consideration the draw weigth i a am looking for?
In this case should i tiller only in the width, not in the thickness?
Or
2. I should also tapper the thickness? The board i'm using is almost 3/4" thick, do you think i should tapper it from 3/4" at the fades to, lets say, 1/2" at the tip?
I really would like to get it rigth, because every bow i've made have ended up 40/45 #...
Can someone help me on this?
Thanks.
Joao from Portugal.
-
http://www.primitivearcher.com/smf/index.php/topic,35312.0.html
this will give you the info you need
-
Jipso,
See the attachment below, this is how I build flatbows. I haven't built a 50-55# oak bow, but I've been very close to that. Take a look and see if this helps you out at all.
If I had to make a guess, I'd say try 3" wide at the fades, tapering to 1/2" wide at the nocks, and an even thickness of 1/2". You can tweak the dimensions during tillering.
-
Not sure on white oak but I have built a lot of Hickory, 66 n-n 2 inches at the fads tapered to 1/2 tips 4 inch handle 1 1/2 fads start at about 5/8 limb thickness
all the way but will usually wind up about 1/2 thickness and easily make 50 lbs @ 27.
Pappy
-
Like Pappy said 2" at the fades is plenty wide
-
Yep, I've made a few following bubby's build along exactly. Only thing I would add, with red oak, maybe a smidge above 1/2" in thickness, especially for 55#. My red oak pyramids are right at 1/2" at the fades.
-
Thaks everyone for the opinion.
I decided to go with a 1,4 cm all the way (0,55").
Do you think i should tiller only in the width or can i rasp in the belly also?
I think that if i am reduced to width tillering only, i will have to reduce much more everytime i need to make a correction, am i rigth?
Best regards
Joao from Portugal.
-
I usually take it off the belly until I get pretty close to weight and draw length and do the fine tuning off the sides. :)
Pappy
-
I'm surprised someone hasn't said it yet but there is no set thickness you just remove wood slowly and carefully to get it where you want it to be. Now a certain thickness might get you close or around your desired weight but it isn't going to work perfect every piece of wood is different there's a lot of variables
-
Guess we shouldn't assume anything around here,I assumed everyone knew that. ??? Good point and very true. ;)
Pappy
-
I'm surprised someone hasn't said it yet but there is no set thickness you just remove wood slowly and carefully to get it where you want it to be. Now a certain thickness might get you close or around your desired weight but it isn't going to work perfect every piece of wood is different there's a lot of variables
I understand that, i just looking for a "starting point"...
Thanks for your opinion..