Primitive Archer
Main Discussion Area => Arrows => Topic started by: Bombadil072 on February 19, 2014, 04:56:24 pm
-
Hey all,
Here are a couple of pics of my first attempts. Like many others, I am (roughly) following the build-along for the Home Depot bamboo arrows. Playing around with a variety of lengths to see what is best, but no clear winner so far.
I have more shafts in various stages of production, and look forward to having at least three that are "matched" by the end of this run.
Thanks in advance for looking!
Jerome
-
Looking real good Jerome ! Are you using dowel glued inside to taper for nocks and field points? I found that to work better when using steel points.
Tracy
-
yours came out better than mine did. good job.
-
Wouldn't have a problem shooting those. Nice job.
-
Fine looking arrows.
-
Looking real good Jerome ! Are you using dowel glued inside to taper for nocks and field points? I found that to work better when using steel points.
Tracy
I have not tried dowel inserts yet. My tool chest is very limited right now, as is my time. I was trying to get usable arrows as soon as possible in this case. I have had one point come undone, but I re-applied it and have had no issues since then. I used hot melt glue and a taper tool, and it seems to have held up ok.
-
Nice looking work there for a first effort....Dowel will cost 38-79 cents. It will pay dividends in the future, esp. if you plan on target practicing any length of time with those...Nice job..
-
Very nice arrows. You did real good on your feather spliced feathers.
A cheap and easy way to make dowel inserts for your points is to take a dowel and put it in a drill press (about 3" of dowel) and turn about 1" of it down to a 1/8th diameter using sand paper. Makes a nice hardwood insert for cheap. I find that the center/pithy part of bamboo is about 1/8" in diameter. I use titebond 111 to glue the insert in to the bamboo.
-
A cheap and easy way to make dowel inserts for your points is to take a dowel and put it in a drill press (about 3" of dowel) and turn about 1" of it down to a 1/8th diameter using sand paper. Makes a nice hardwood insert for cheap...
Anybody have an effective suggestion for doing this without a drill press?
Another issue I have already noticed is fletchings lifting off of the shafts. I used Duco cement, and I don't know if anyone has a better idea for unfinished bamboo.
Thanks,
Jerome
-
Jerome,
I like using bamboo skewers, you can get a lot of them for a dollar. They are about 1/8" in diameter, if they are too big a little sandpaper will get it there pretty quick. I use gorilla glue for the inserts, it expands in any voids and strengthens the tips. as far as the feather coming off I would sand the cane/boo a bit to get the waxy like outer covering off and then glue the feathers, then add a thread wrap at both ends. I like super glue and a fletcher myself, but Duco and you eye will work too, just takes longer.
DBar
-
Thanks for the skewer suggestion. I will definitely put that to good use right away.