Primitive Archer
Main Discussion Area => Bows => Topic started by: KShip85 on February 11, 2013, 09:54:05 am
-
I was doing some reading awhile back on for a side wood working project and read how some people will soak pieces of wood in denatured alcohol when green and then remove and let dry and it will keep from checking. My question is has anyone ever tried doing this and if so is it possible to use the wood in a bow in the form of glued in levers or tip overlays or handle material? I wasn't sure if the alcohol soak would weaken the wood or make it difficult to glue. Thanks for any help.
Kip
-
Not sure on the wreaking or glue problem but I have a friend that does a lot of bowl turning and that is what he does with green un seasoned wood and say it will stop the checking, made me a bowl out of 3 month old Walnut that we cut on the farm it hasn't been sealed and has no checks yet, so I guess it works. :) He says it pulls all the moisture out and leaves it in it for about a week.Never thought about using it in bow work till now. ??? :-\
Pappy
-
I've seen alcohol used while bows were being made but it was the bowyer that had soaked up the alcohol. ;D
-
;) ;D ;D ;D seen that also Pat. ;) ;D
Pappy
-
I've seen alcohol used while bows were being made but it was the bowyer that had soaked up the alcohol. ;D
Nicely done pat haha ;D
-
Haha, I do well to keep from injuring myself or ruining a stave sober, I don't need any more impairments ;)
-
Pat I gotta give ya a 10 on that one.
And ya wasn't referring to me was ya? LMAO
-
...if the shoe fits! ;D
-
Haha, well if neither of you masters have tried it and no one else has really chimed in I guess I'll be the guinea pig and give it a go :). I've secretly already had a piece of sycamore that's got some curve to it soaking and now drying. Think I'll turn it into levers for a molle :)
Kip
-
It seems like in every other use it chases out water, so it should work. Are you going to use like a sealed PVC tube? I would be curious how much $$ it would cot to fill it. It seems like the stave would need to be as lean as possible to keep cost down. Please posts your results Kip.
Tracy
-
Hey Tracy, for a stave I'd most likely try a sealed capped 3" or 4" PVC pipe. Right now I've got a large block I cut from a sycamore to use as spliced in levers on a molle. Just took it out of the alcohol bath and it's drying now. I did a test run on a cross cut sliver and it looks like it did a good job stopping the checks from happening. I'll give a stave a go some time and post some results as well. I have 7 gallons or so of alcohol on hand, caught them for half price a few months ago at menards and stocked up. I might try cutting an Osage branch stripping the bark and soaking it just to test.
Kip
-
I've seen alcohol used while bows were being made but it was the bowyer that had soaked up the alcohol. ;D
that is top shelf material there Pat