Primitive Archer

Main Discussion Area => Bows => Topic started by: darwin on July 10, 2012, 03:50:43 pm

Title: bendy handle
Post by: darwin on July 10, 2012, 03:50:43 pm

I'm about to start tillering out my first bend in the handle bow and was wondering if anyone had any tips. i would like just a slight bend and was wondering if it was as simple as it seems in my head

Title: Re: bendy handle
Post by: JW_Halverson on July 10, 2012, 04:36:23 pm

Keep an old scratched cd, coffee can lid, or 45 rpm record handy.  When you put it on the tillering tree, hold the circular disk of choice up to compare against the curve of the bow.  They should match.   

Title: Re: bendy handle
Post by: Pat B on July 10, 2012, 05:43:39 pm

I generally get the mid limb bending first then bring the center of the bow around near the end. I like to feel the handle bend only when I approach full draw.

Title: Re: bendy handle
Post by: Dictionary on July 10, 2012, 05:53:30 pm

from my experience, its best to let it bend a little less than needed than more than needed. More than needed= set in the handle and this results in a very sluggish bow. take pats advice

Title: Re: bendy handle
Post by: crooketarrow on July 10, 2012, 05:58:26 pm

I tiller my limbs out like always (evenly) takeing the handle down as I go. I like leaveing it a few pound heavy at this stage. When I have the tiller close I'll tiller on down through the fades and to the handle. KEEPING THE BEND IN THE HANDLE I WANT. When you get the handle been you want it only takes a few scrapes and sanding to even up the limb tiller to the handle. Keep sanding evenly untill you have the poundage you want.
  HOPE THAT MAKES SOME SINCE TO YOU. Or do as I did when I learned jump right in there you'll be fine. But go slowwwwwwwwwwwwwww once the woods off there's no going back.

Title: Re: bendy handle
Post by: darwin on July 11, 2012, 11:04:04 am

thanks guys

Title: Re: bendy handle
Post by: Badger on July 11, 2012, 11:24:00 am

  For some bendy handles are easy, I have been making bows for a long time and I still struggle, my eyes just don't like to see the middle bend. I do like Pat says now, I tiller out to about 25" and then slowly scrape down the center 8" of the bow till I have the same weight at 28". I really don't see or feel the bend much here.

Title: Re: bendy handle
Post by: George Tsoukalas on July 11, 2012, 11:40:37 am

Gotta go but see Building  a Board Bow on my site. Jawge
http://georgeandjoni.home.comcast.net/~georgeandjoni/index.html