Primitive Archer
Main Discussion Area => Bows => Topic started by: Fred Arnold on June 16, 2012, 05:59:41 pm
-
I'm getting ready to add sinew backing to a bow and found while searching that acetone was recommended to degrease the wood before applying the sinew. I'm wondering what other products may be used in place of the acetone since I'm a ways from town and don't have any.
I've got mineral spirits, isopropyl alcohol, denatured alcohol, lacquer thinner, and other products on hand in the shop but wanted to find out before proceeding. Didn't want to run to town and spend the money if something else would work.
Thanks, Fred
-
Dish soap and very hot water.
-
Lye,Wood ashes and hot water,are the old traditional method.
-
I've got dish soap and a 55 gallon drum of wood ashes. Do I need to completely dry the bow again before proceeding with the sinew application?
-
Fred, you want to degrease the bow just before adding the sinew. The wood being wet will help the glue saturate the wood well. I washed the back of the bow with Dawn dish soap and warm water and rinsed it with boiling water to clean the last 2 bows I sinewed and it worked great...not nearly as toxic as acetone or other solvents.
-
Acetone can absorb through the skin fast enough to be detected n the blood in a short time.( Learned this in an auto body class) Be sure to wear gloves when you use it guys.
-
You can leave it as is if you dont want to use anything on it. Rough it up good and lay the sinew down.
-
Thanks for all your help. While the latest answers came in I was out in the shop applying the sinew. Hope I didn't mess up by not roughing up the back.
I did a double Dawn cleansing and double rinse with super hot water. After the first washing the rinse seemed to bead up in a couple of spots so I did a repeat.
Ended up using some Knox gelatin that I've had on hand for years. Seemed to work well and not really as messy as I thought it would be although extra sinew kept sticking to my hands like melted cotton candy.
Brought the bow back into the living area as the humidity in the shop seems high and wanted to try to shorten the drying time.
Should a couple weeks be enough before applying snake skin?
-
I've got mineral spirits, isopropyl alcohol, denatured alcohol, lacquer thinner, and other products on hand in the shop but wanted to find out before proceeding. Didn't want to run to town and spend the money if something else would work.
Thanks, Fred
I know it's too late, but the primary ingredient in lacquer thinner is acetone, same with nail polish remover. All I use anymore is a bottle of nail polish remover one of the girls left in our spare bathroom. I don't rough up my bows that much anymore. Normally I just run some coarse sandpaper over it right before I degrease.
Should a couple weeks be enough before applying snake skin?
I would say yes, if the bow stays in the house 2 weeks is long enough to let it dry before snakeskin. If I were you I'd shoot it a few times before applying the snakeskin. I don't like to apply snakeskin until I have the bow shot in and ready to finish.
George