Primitive Archer
Main Discussion Area => Bows => Topic started by: hook on May 04, 2012, 07:10:31 pm
-
I have available:
Hackberry
Black locust
Maple (red and sugar)
elm (not sure if its american or red)
Sourwood
I have a hankerin' to try one of these sapling bows. I was thinking about an 1 3/4" diameter would be easy to work with.
But then again I have never attempted one so I don't know and I am soliciting free advice
-
I really like to use elm saplings, go for it!!!!
-
Looks to me like you should be making at least six bows. One of each. If I had to choose just one from the list, it would be the hackberry.
-
Interesting you say Hackberry would be your top choice as I have a stave at the minute.
Personally I would go for the Elm as I have seen it make excellent Sapling bows, though heat treating was used at the time.
-
Bevan said it best, make all six.
-
Bevan said it best, make all six.
yup :)
-
I've used all but sourwood in one form or another. Leave the stave a few inches longer than usual for you, Sadie. No need to decrown. Jawge
-
I think hackberry makes a good sapling bow, if the sapling is wide enough to get at least an oval shaped cross section out of. I think that is a very good cross section for a hackberry bow. I like almost any sapling to make a bow that will make a bow, ;D. Mulberry makes a fun sapling bow, very light wood and it will shoot fast. And not take too much set, usually.
-
Hook? Hello? You out there?
I guess not.
Here's hoping he's going wild in the shop with all six saplings at once!!! ;D Get'em, Hook!
-
JW,
I'm out here! sometimes way out here. lol. I was tending to the honey do list this weekend. I have read some good things about hackberry and really wanted to try one. I just didn't know if it would be ok with a crown on the back or not. I am also unsure of the diameter that would work. I would like to make a 50 pounder or so and I believe my draw length is about 30" Any size suggestions? Also lay out dimensions?
thanks
-
Double your draw length and add a few extra inches for extra insurance. Make the thick end of the sapling be the bottom limb and taper it to the same dimensions as the width of the upper limb. Once you got that done, all you need to do is correct the tiller.