Primitive Archer
Main Discussion Area => Bows => Topic started by: TurtleCreek on September 28, 2011, 05:16:21 am
-
When blending the fades of the riser/handle area into the limb, should the end of the fade go past the widest part of the limb if making a pyramid style bow? I read that the fade should be feathered or blended into the starting limb thickness about 1/8th to a 1/4 inch past the widest point. What do you guys think?
-
I'd go for a 1/2 - 1 inch then you've got something to work with. The only thing to watch for with a pyramid is too much bending out of the handle so this is a wise precaution.
-
I generally mark center, mark two inches each way for a four inch grip, then two more inches from the end of the last marks for the fades, that's where the wide part of the bow is, then straight taper from their, Bub
(http://i623.photobucket.com/albums/tt320/bubncheryl/blade-7.jpg)the pics a little blurry but hope it helps
-
From what I've read, theoretically, in a pyramid bow the thickness taper should be even or parallel from the fade to the tip. However, with the ones I've made thereis a gradual taper going slightly past the fade point. Are you using a board or a stave, this can make a difference too, due to the changing crown or dips that likely occur on the back of a stave.
-
Right now I am roughing out a stave of white ash for a sort of Modoc style bow. The back of the stave is clean with no knots and basically flat. Although I do plan on using a hickory board in the future.
-
Thanks for the pic Bubby. Even though it's a tad blurry, it clears things up for me:)