Primitive Archer
Main Discussion Area => Bows => Topic started by: Easternarcher on December 03, 2010, 03:16:48 pm
-
Just looked at Marc's stringing method poll above and got to thinking...
When making a double nock for stringing purposes with a double loop stringer, are the grooves equal depth into the tip or is the outer groove abit less? I'm wondering if the stress on the inner groove ican be enough to split off the tip when stringing.. ???(that would be a very bad thing).
I'm assuming this is done with horn nocks or laminated hardwood tips mostly.
Since I was planning on a couple of ELB's after Christmas, I thought it would be good to know beforehand. Personally, I'd likely use the push-pull anyways, unless the draw weight is a bit much for me.
Comments?
-
Well, that is not an easy question to answer. If your stave is perfectly straight then yes. If you have a bit of a leaner then if you leave the nocks wide you can cut the off side deeper to track the string on the handle or to track it better. You would do both nocks. Later you can even them off with sandpaper so they are even. Know what I mean? Ha? :) Jawge
-
Well, that is not an easy question to answer. If your stave is perfectly straight then yes. If you have a bit of a leaner then if you leave the nocks wide you can cut the off side deeper to track the string on the handle or to track it better. You would do both nocks. Later you can even them off with sandpaper so they are even. Know what I mean? Ha? :) Jawge
Not quite what I was getting at George....I'm talking about the double nock grooves to accomdate a loop stringer cut into the top of the tip overlays. Or is the outer notch only cut from the sides???
-
I put double nocks on a war bow I built but it had hern nocks. I think if you take it easy and pull slow but stead you shouldn't have a problen with the limb splitting. It is not like the string nocks that get a lot of abuse every time you shoot.
-
Hey there
I would not be too worried about double nocks splitting your bow tip when stringing, enev if the stringing nocks are cut deep. You only pull the bow enough to get the string at brace height. Tension on the stringer is not enough to jeopardize the tip's integrity. I'ts not as if you were pulling that bow back to 30'' with the stringing nocks. I'm talking straight bows here. If you were to string a very reflexed bow with double nocks, there would be more risk of the tips splittiing since stringer tension would be greater.
Hope this helps
Matt
-
Hey there
I would not be too worried about double nocks splitting your bow tip when stringing, enev if the stringing nocks are cut deep. You only pull the bow enough to get the string at brace height. Tension on the stringer is not enough to jeopardize the tip's integrity. I'ts not as if you were pulling that bow back to 30'' with the stringing nocks. I'm talking straight bows here. If you were to string a very reflexed bow with double nocks, there would be more risk of the tips splittiing since stringer tension would be greater.
Hope this helps
Matt
YAh, that's what I'm referring to....
And I'm referring to trad. ELBs here as well. WITH horn nocks.
Thanks guys.