Primitive Archer
Main Discussion Area => Bows => Topic started by: Cacatch on March 24, 2010, 04:11:22 pm
-
I recently cut a very nice straight white elm tree, about 4.25 inches wide down at the base. If I could split it I would theoretically be able to get 2 bows from one half of the log. My question is, would splitting this wood be adviseable? The last thing I want to do is ruin one of them. I would just like to not waste any wood if I could split off the other half and make a bow out of it, instead of making a pile of chips with my draw knife. Would it split straight ya think?
Thanks,
CP
-
If it was me, i would only try to get one bow out of it. 4 1/4 " at the butt end is not very big. Plus Elm is a devil to split ! but it does make nice bows !!
-
i dont know why every one thinks elm is so damn hard to split
its easy,well easier than hhb
i would rather split elm all day long over a half day of splitting hhb
but would rather use hhb
i think(in my experience atleast) if you leave elm or hhb sit in log form to dry for a few months
it splits a little straighter and a little easier
but like i said,thats my experience with it
-
Thanks for the responses guys.
I have split red elm before, after it dried for about a year and like Sailordad said, it was very easy to split, in fact one of the easiest woods I have ever split. I just set the wedge in one of the natural checks (I didn't seal the ends) and it split like a dream. But then this is white elm, which I have made a bow from, but it was from a sapling.
I think I might go back to the tree and try splitting the fattest limbpiece I can find left that didn't make the cut for bows. The tree has only been down a week, and was very much healthy and alive so it's pretty green. I'll let you know how it goes.
CP
-
Cacatch, I agree Red Elm and White Elm are two different animals.....Good luck !
-
Thanks John.
I cut a small limb off of it too, about 1.75" at the base, tapering to about 1" at the top, 68" long, which I have been whittling down and speed drying as I go. I think it will make a very nice little bow, provided I get the tiller right which will be a little tricky on this particular piece, I think. I tried posting some pictures a while back and didn't have any success. But I may give it another go if this piece turns out, cause it is an interesting little stick and like I said, if I do it right should make a very nice little bow. White elm is my favorite white wood.
-
Kerfing the log makes it a lot easier to split and with less waste
-
Good point, thanks Marc! If I end up trying to tackle one of the larger logs I'll take the chainsaw and kerf as far in as I can safely go. This weekend I'm going to go after one of those limbs if I can find one big enough. If I remember right I did have to leave some that were too crooked to mess with.
CP