Primitive Archer

Main Discussion Area => Bows => Topic started by: youngbowyer33 on March 09, 2010, 10:09:19 am

Title: tru-oil spray can
Post by: youngbowyer33 on March 09, 2010, 10:09:19 am

mine stopped spraying..... ???It's still about half full, and it just stopped. I've tried shaking it for a long time, I've tried to clear the hole where it comes out, and it won't work. I'm in the middle of putting the finish on my first red oak bow, and i would like to finish it. Should i contact the company? thanks

Title: Re: tru-oil spray can
Post by: youngbowyer33 on March 09, 2010, 10:10:52 am

oh and also has this ever happened to any of you and do you know how i might fix it? thanks again

Title: Re: tru-oil spray can
Post by: Eric Krewson on March 09, 2010, 10:31:03 am

Don't know if you know this but when you use a spray can, before and you put it up, you should turn it up side down and spray for a few seconds  until the nozzle clears. This way you won't have stopped up nozzles.

I have soaked stopped up nozzles in lacquer thinner and sometimes cleared them , sometimes.........

Title: Re: tru-oil spray can
Post by: venisonburger on March 09, 2010, 02:51:43 pm

Try putting a different nozzle on.
VB

Title: Re: tru-oil spray can
Post by: Pennhawk on March 09, 2010, 03:12:37 pm

Every can I  ever used did just that try soaking nozzle in acetone to clean it. Any more I buy the bottles and rub it on.

Title: Re: tru-oil spray can
Post by: youngbowyer33 on March 09, 2010, 06:24:00 pm

alright thanks i will try harder to clear out the nozzle. and VB, how do i remove it?just pull?

Title: Re: tru-oil spray can
Post by: youngbowyer33 on March 09, 2010, 07:19:23 pm

IT SPRAYS!!!!!!!!!!!!!!i picked it out a bit more with a pin then let it soak in some nail polish remover for 5 mins then shook it a bit and it sprays again!thanks guys!