Primitive Archer
Main Discussion Area => Bows => Topic started by: Blacktail on January 09, 2010, 12:53:05 pm
-
o.k. when i get rich and famous...i want to try some bamboo and yew or bamboo and hickory bows...SO,who knows about glues...i am looking at bow gripp and was wondering what you thought about it..and if it needs a heat box to dry or if it can dry in house temps..john
-
John, The best wood/wood glue(considering boo as wood) is Urac. It will set at room temps. TBIII is also an option. I believe Bow Grip is for glass/wood applications.
-
thanks pat.you allways seem to be there in time of need...john
-
i just want to make sure that i am on the same page..i seen this in 3 rivers urac-185 for 12.95...can i get this at a hardware store...john
-
I don't know if or what hardware stores sell Urac. I get mine straight from Nelson. They are on the internet if you want to check them out.
-
I believe it is the Nelson Paint Co. You can order it directly.
-
Yep....thats where I get mine too......
-
I've had very good luck with TB3, and use nothing else these days. Cheap, easy to clean up, waterproof, and very strong.
-
well,i have some tb3 and might give it a try ...now i need to find some bamboo that is all ready flattened
-
Blacktail,
I have used TBIII with great success. I have used it on bamboo backed red elm and bamboo backed oak. I would caution you not to oversqueeze the joint on glue up. Be sure to cover both surfaces with glue. I use a putty knife to get it smooth. I also use stretch wrap to bind everything together. Glue squeeze can be seen and you don't need anymore pressure than that. I would however make sure that everything is warm (room temperature) and I would wait a little longer than 24 hours before I tried to bend it. Also, take the stretch wrap off after 24 hours so the glue can finish drying.
I can't comment on Urac as I am not familiar with it. I am not overly impressed with bow grip, which is a two part epoxy. I used bow grip in a handle forward design and did not find it to be any better than TBIII. That is just my opinion and may not be the same as others.
-
hey John, remember the bamboo backed Yew that Buffalo made at the first bowyers gathering? it was over 70#s and he dry-fired it! the glue held up, but there was a split in the handle and we glued it back together. he dry fired it again at the indoor, and nothing failed, he pulls this bow to about 30", anchors by his ear. ::)only buffalo... anyway, I used tb3 to glue that together, and have made several others without any failures. in fact, i tried to remove a bamboo back because there was a gap that I didnt like, i tried to drawknife it and it would not seperate from the yew without leaving wood behind, i had to re-sand both to reglue it. i also like it for sinew and snake skins. never tried urac, but I know Gordon uses it.
-
Used tbIII on both my BBI's and Justin Snyder's rubberband clamp method. Both bows are holding up fine and haue had a few hundred shots through each of them. David Knight is hard to beat for glue up ready bamboo!
-
I'll second David Knights Bamboo......comes ready to go.