Primitive Archer
Main Discussion Area => Bows => Topic started by: wodpow on December 03, 2009, 02:53:00 am
-
Is it normal for bows to get stronger when the wood is subjected to the dry heat of a gas furnace in the winter or is it just me ?
-
i have zero experience with self bows, or even board bows, but.... when the moisture content in a piece of wood goes down significantly, it looses elasticity, and i would think it definitely would raise the poundage on a bow... unfortunately it makes the wood more brittle, and depending on species...it could easily fail in compression or tension depending on the weakest point.
Kirk
-
Getting a bow too dry is a recipe for failure. I like to try and keep my bows around 8% mc. Every point in oisture makes a difference in the stiffness on the bow. Most woods will get stronger in compression but if they get too dry they get weaker in tension, this usually happens below 6% moisture. As far as I am concerned trying to mangae the moisture in a bow can be kind of a pain. If posible select a wood that works best in your own climate. Dry climates favor woods like hickory, elm, hornbeam, moister climates locust or osage or some of the exotics. Maple seems to work well for me in my climate here in so cal, maintains about 8% to 9% mc.
-
I would think getting a bow to the proper dimensions and pull, then sealing it properly, would keep it happy where ever you go.
-
It's not quite as simple as that Makenzie. It takes a constant vigilance for good bow care in these types of bows. Once you understand the importance of proper moisture content in wood and it's relating effect to good bow health then good things start to happen. Bows quit breaking seemingly for no reason, bows take less set and you gain a greater confidence in your bow making skills. ART
-
It's not quite as simple as that Makenzie.
Well I'm not implying that one coats the bows and never goes back...though it may have seemed that simple. I wax or oil my bows before I go anywhere with them...typically after every use, too.
-
Yes, if it was green when you put it by the furnace. Loosing moisture makes the wood stiffer. :) Jawge
-
Its just two 60#+ Osage 70" long bows have taken to stacking at about 26"" they were smooth drawing out to 28"@ 63# really don't want to loose any draw weight at first I thought it was me till I scaled them. The wood was three years old and must of been retaining moisture when I tillered them was just curious. They are not at the heat source it's just that winter and dry heat would make my grand mothers old dining room furniture get loose till she had a humidifier put on her furnace It was some really old tables and chairs with hide glue glued joints. will tiller go back to where I had it latter on? there not sealed up real tight maybe that did it.