« previous next »
Pages: [1]

Author Topic: Knot holes  (Read 1343 times)

0 Members and 1 Guest are viewing this topic.

Offline Muskyman

  • Member
  • Posts: 993
Knot holes
« on: August 23, 2022, 05:37:36 pm »
Making my third bow from hickory I cut down in my woods.
It’s got a couple pretty big knot holes in one limb a little off center. Should I fill those?
Probably about a half inch +- around on the bigger one.

Any thoughts
Thanks
Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: Knot holes
« Reply #1 on: August 23, 2022, 06:11:11 pm »
Welcome to PA.  Pics would help to make a decision but if they are clean knots or knot holes and have enough room around them you should be OK to just leave them as they are. You can fill them if you like.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline Muskyman

  • Member
  • Posts: 993
Re: Knot holes
« Reply #2 on: August 23, 2022, 10:43:06 pm »
Trying to post pictures
Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: Knot holes
« Reply #3 on: August 23, 2022, 11:11:11 pm »
If the back ring is unviolated into the knots you should have no problems with the knots. Keep the tiller a bit stiffer at the knots.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline Muskyman

  • Member
  • Posts: 993
Re: Knot holes
« Reply #4 on: August 23, 2022, 11:27:18 pm »
Back is okay, fill them?
Logged

Offline ShorterJ

  • Member
  • Posts: 42
Re: Knot holes
« Reply #5 on: August 24, 2022, 01:34:03 am »
If it were mine I would just follow the grain around the knots and leave them alone.  Filling them should be fine too if you want.  Hickory is pretty tough stuff.
Logged

bownarra

  • Guest
Re: Knot holes
« Reply #6 on: August 24, 2022, 01:45:11 am »
When laying out a bow with knots you simply follow the grain around it. DO NOT cut straight lines either side of them! EG. on your width taper.
Logged

Offline George Tsoukalas

  • Member
  • Posts: 9,425
    • Traditional and Primitive Archers
Re: Knot holes
« Reply #7 on: August 24, 2022, 09:12:15 am »
All good advice. Also, leave the knotted areas wide enough with wood equal to the width of the bow. Jawge
Logged
Set Happens!
If you ain't breakin' you ain't makin!

Offline Muskyman

  • Member
  • Posts: 993
Re: Knot holes
« Reply #8 on: August 24, 2022, 05:35:09 pm »
I’ll keep that in mind on my next one. To late for this one, but sound advice I’m sure..
I’ve seen pictures of some of the bows on this site and I’ve seen bows that just leave me in awe.
The bow in my picture is floor tillered and on the rack with a tillering string.
I figured if it blows up on me I’ve still learned a few things.
Logged
Pages: [1]
« previous next »