Author Topic: Vine maple stave help  (Read 1113 times)

0 Members and 1 Guest are viewing this topic.

Offline afurman25

  • Member
  • Posts: 19
Vine maple stave help
« on: August 25, 2022, 03:18:08 pm »
Hello all,

I am fairly new (about 4 bows in) to building bows. I’ve got a 72” vine maple stave that I have some questions about.

1. At what point is the best time in the process to heat bend the stave. It’s about 4” wide and 2.5-3” thick at this point.

2. At one end there is some (what looks like) spalting. Is this usable wood? I was planning on keeping it and soaking it with a penetrating epoxy. What do you guys think? Should I just cut it off? I would lose about 4” of wood.

3. I have a 30” draw.my target weight would be around 50lb. What dimensions for design are recommended? I’m not building this for hunting so keeping it long is not an issue. There is a fair amount of crowning. I’m looking for limb width/ where to start tapering the width of the limbs.

I’ve attempted to read as much as possible before posting questions but I can find clear answers.



Offline TimBo

  • Member
  • Posts: 1,047
Re: Vine maple stave help
« Reply #1 on: August 25, 2022, 03:45:26 pm »
Spalting is produced by a fungus, so if it looks fungus-y, that part (at a minimum) needs to come off.  Was this cut from a living tree?  How was it stored? 

Offline afurman25

  • Member
  • Posts: 19
Re: Vine maple stave help
« Reply #2 on: August 25, 2022, 04:15:46 pm »
I purchased the wood from Craigslist in my area. Not sure how it was stored but the seller said he used to teach bow building/ seemed very knowledgeable so I would assume he stored the wood appropriately. Ends were sealed on other staves other than this end.this may be why this end got spalted.  I see others have used spalted maple in lam bows but didn’t know if this would fly on a limb tip on a self bow. It seems to be stable but I can’t tell 100%.

Offline TimBo

  • Member
  • Posts: 1,047
Re: Vine maple stave help
« Reply #3 on: August 27, 2022, 03:58:49 pm »
Since the tip won't be working (much), it might be ok.  Also since it's on the tip, you would have plenty of stave to cut off a bit (lengthwise, with the grain) for a bend test. 

Offline afurman25

  • Member
  • Posts: 19
Re: Vine maple stave help
« Reply #4 on: August 31, 2022, 01:00:52 am »
That is a great suggestion! Thank you.

Offline TimBo

  • Member
  • Posts: 1,047
Re: Vine maple stave help
« Reply #5 on: August 31, 2022, 10:24:06 am »
Good luck with it!  The other thing is that with 72", you could easily just make a shorter bow, even if it ends up needing to bend in the handle.  I would do a bend test even then to be safe; the idea of compromised wood would make me nervous.  Hopefully it only made it as far as that spot you can see though.