« previous next »
Pages: 1 [2]

Author Topic: osage bow dimensions  (Read 9921 times)

0 Members and 1 Guest are viewing this topic.

Offline david w.

  • Member
  • Posts: 1,823
Re: osage bow dimensions
« Reply #15 on: May 25, 2008, 06:36:02 pm »
my board is 1 1/8" thick i was just going to leave it the full thickness there and bring it 1/2 past the fade out.  then i was going to glue on a 1/2 piece of cherry on top of that to make it 1 5/8.

this handle is 1" wide so it pretty narrow but since it thick i think it will hold up
Logged
These pretzels are making me thirsty.

if it dont go fast...chrome it - El Destructo

CutNShoot

  • Guest
Re: osage bow dimensions
« Reply #16 on: May 26, 2008, 11:32:47 am »
knife edge is Very Very thin on the end edges of the piece after sanding where it fades out. You can see light through them.
Logged
Pages: 1 [2]
« previous next »