« previous next »
Pages: 1 [2]

Author Topic: 1st "Successful" bow.  (Read 2677 times)

0 Members and 1 Guest are viewing this topic.

Offline MM2

  • Member
  • Posts: 35
Re: 1st "Successful" bow.
« Reply #15 on: August 18, 2020, 04:25:02 am »
What a beauty! Congratulation!
Logged

Offline Will B

  • Member
  • Posts: 1,024
Re: 1st "Successful" bow.
« Reply #16 on: August 18, 2020, 12:19:43 pm »
Very nice bow and great bend!  Congrats!!
Logged

Offline gifford

  • Member
  • Posts: 478
Re: 1st "Successful" bow.
« Reply #17 on: August 18, 2020, 02:27:03 pm »
Very nice bow, great lines and tiller. For your first one, you knocked it clean out of the park. Way to go.

Logged

Offline medicinewheel

  • Member
  • Posts: 3,629
Re: 1st "Successful" bow.
« Reply #18 on: August 20, 2020, 10:20:47 am »
Spot on tiller!
Logged
Frank from Germany...

bownarra

  • Guest
Re: 1st "Successful" bow.
« Reply #19 on: August 20, 2020, 11:39:49 am »
You did well :)
When evaluating a new bow my first question is does it have any handshock? If not the tiller is spot on.
One area to be careful with is the shelf and thickness transistion combo. Ideally you want the upper fade at a good thickness where you start the cut in of the shelf. You need thickness to compensate for the reduced width at the pass. Not enough stiffness in this area will cause bow explosions ;)
Logged

Offline RyanY

  • Member
  • Posts: 1,999
Re: 1st "Successful" bow.
« Reply #20 on: August 20, 2020, 01:45:44 pm »
Excellent first success. Good job!
Logged

Offline Parnell

  • Member
  • Posts: 5,556
Re: 1st "Successful" bow.
« Reply #21 on: August 21, 2020, 12:22:42 pm »
Hey, congratulations.  My first was similar but had the tape.  Well done on the tiller.
Start gathering staves now!
Logged
1’—>1’

Offline Hans H

  • Member
  • Posts: 420
Re: 1st "Successful" bow.
« Reply #22 on: August 21, 2020, 12:46:33 pm »
very nice, you made a good job  :D
Hans
Logged
Hans,      Bavaria, Germany
Pages: 1 [2]
« previous next »