« previous next »
Pages: [1]

Author Topic: Cracked hickory board  (Read 969 times)

0 Members and 1 Guest are viewing this topic.

Offline Kidder

  • Member
  • Posts: 637
Cracked hickory board
« on: July 27, 2020, 12:06:59 am »
Hi all. Working on a hickory board bow. Close to floor tiller and I noticed a crack running down the belly and around the side of the lower limb. As I see it I could scrap it and start over, fill it with CA and hope for the best, narrow the limbs significantly (probably come out at 1.25 inches wide), or cut the bottom limb off and turn it into a take down project (Although I don’t feel competent with a take down at this point). What are the collective opinions? Thanks in advance.
Logged

bownarra

  • Guest
Re: Cracked hickory board
« Reply #1 on: July 27, 2020, 12:39:57 am »
You've got your oprins correct. Just do what you feel. :)
If you absolutely had to get a bow out of it. I would narrow the limbs. It is a shame the check goes around the edge....it could be fine as is but it is risky. You could try tillering it to full draw with nothing more than superglue in the check. If it survives then wrap with fishing braid or similar.
Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: Cracked hickory board
« Reply #2 on: July 27, 2020, 06:33:04 am »
That crack is running with the grain.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline Eric Krewson

  • Member
  • Posts: 5,432
Re: Cracked hickory board
« Reply #3 on: July 27, 2020, 06:54:33 am »
I wouldn't trust that limb, I would cut it off and splice in a new limb at the handle.

I have replaced bad limbs a bunch of times.





Logged
Pages: [1]
« previous next »