« previous next »
Pages: [1]

Author Topic: Black locust pin knots  (Read 1338 times)

0 Members and 1 Guest are viewing this topic.

Offline Jjpso

  • Member
  • Posts: 101
Black locust pin knots
« on: July 05, 2020, 02:16:45 am »
hello there!! Yesterday I started a black locust bow. I removed the bark and sapwood, chose a heartwood ring and chased it, when I was working around 2 pin knots, they broke, and now I have 2 small holes where the pin knots were. do you think its ok to go on, or should I chase another ring? The grain goes around it, but I don't know...  I have an Osage bow with this same thing (it wasn't made by me), and the pin knots were even cut trough, and never had a problem, but I am not sure with black locust.. thanks a lot, regards from Portugal!!!
Logged

Offline simson

  • Member
  • Posts: 2,310
  • stonehill-primitive-bows
    • stonehill-primitive-bows
Re: Black locust pin knots
« Reply #1 on: July 05, 2020, 02:56:14 am »
Hi my friend,

this isn't a problem at all - go on and good luck!
Logged
Simon
Bavaria, Germany

bownarra

  • Guest
Re: Black locust pin knots
« Reply #2 on: July 05, 2020, 03:33:16 am »
It looks like you've done a good job to me :) Black locust is my favourite wood. Go slow and aim for perfect tiller before bending it very far.
Logged

Offline Jjpso

  • Member
  • Posts: 101
Re: Black locust pin knots
« Reply #3 on: July 05, 2020, 07:09:20 am »
thank you both for you answers!   Simon, my friend, I was expecting you to show up...;) I hope everything is well with you!!!
Logged
Pages: [1]
« previous next »