Ryan, first I zigzag edge of glass with very short flakes. You need to build convexity so flakes will travel further. Raise edge to one side and use Ishi on next pass to increase length of flakes. Raise edge and repeat with Ishi on opposite face. I try and get my flakes to go passed center on my 3rd pass and remove all flat areas or shiny part of glass. To build pressure with the Ishi you need to press straight in hard and then squeeze with legs while still pushing straight in with hands. This will get your flakes to travel further than with hand flaker. Rember flakes like to travel up ridges and humps , but don't like to travel on concave and flat areas, remember to try and build nice smooth convexity and your flakes will start to travel further. Cross section is rarely talked about but very important for flake travel whether pressure flaking or using a giant dogwood billet. If you ever get a chance to see James Parker knapping ask him about cross section , the man is a master knapper to say the least. I hope this helps and isn't to confusing. Opps didn't see Chippintuff reply so a little over lap. Bob
