« previous next »
Pages: [1]

Author Topic: Pressure Flaking Position for Beginners  (Read 1920 times)

0 Members and 1 Guest are viewing this topic.

Offline Dalton Knapper

  • Member
  • Posts: 339
Pressure Flaking Position for Beginners
« on: February 23, 2016, 05:28:57 pm »
Below is a picture I posted on a couple of sites with the basic position and mechanics for effective pressure flaking. Bear in mind there are literally 100 ways to pressure flake and this is but one. Also know that to run long flakes you will not only have to hold that position and not let it change until you detach the flake, but your platform and convexity of the piece are important as well. I'm not a burly fellow, so I need all the power I can get from my legs and hands. Maybe it will be helpful to some:

Logged

Offline loon

  • Member
  • Posts: 1,307
Re: Pressure Flaking Position for Beginners
« Reply #1 on: February 23, 2016, 05:52:30 pm »
Nice, will give this a try with bottle bottoms.
Are you going into the hand with this?
For building a platform, you wouldn't go so much into the piece, right?
« Last Edit: February 23, 2016, 06:02:18 pm by loon »
Logged

Offline nclonghunter

  • Member
  • Posts: 1,779
Re: Pressure Flaking Position for Beginners
« Reply #2 on: February 23, 2016, 06:37:32 pm »
Excellent illustration of the process... :)
Logged
There are no bad knappers, only bad flakes

Offline Tracker0721

  • Member
  • Posts: 736
Re: Pressure Flaking Position for Beginners
« Reply #3 on: February 23, 2016, 09:22:16 pm »
Looks about right. And I've found the angle of the flaker along with the direction of force to change flake size and length. And always remember that a good stabbing pressure into the rock before swiping down will produce nice flakes.
Logged
May my presence go unnoticed, may my shot be true, may the blood trail be short. Amen.
Pages: [1]
« previous next »