« previous next »
Pages: 1 [2]

Author Topic: Dipping tubes  (Read 5689 times)

0 Members and 1 Guest are viewing this topic.

Offline DC

  • Member
  • Posts: 10,396
Re: Dipping tubes
« Reply #15 on: June 04, 2015, 08:42:41 pm »
The results of my efforts. I'm experimenting with the stain, that's why they're different.
Logged

Offline Danzn Bar

  • Member
  • Posts: 4,166
Re: Dipping tubes
« Reply #16 on: June 04, 2015, 08:56:31 pm »
They look pretty good, can we get a close up of the points..................
Thanks
Dbar
Logged
Integrity is doing the right thing when no one is looking

Offline DC

  • Member
  • Posts: 10,396
Re: Dipping tubes
« Reply #17 on: June 04, 2015, 09:21:18 pm »
There ya go! They are made of duplex nails with a piece of aluminum pressed on and turned. I was trying different shapes to stop them from bouncing out of the targets at the range. Then they got new targets
Logged

Offline Danzn Bar

  • Member
  • Posts: 4,166
Re: Dipping tubes
« Reply #18 on: June 04, 2015, 09:25:39 pm »
I really like duplex points, and this is very interesting  :-\ :-\...............did they make a difference at the range?
DBar
Logged
Integrity is doing the right thing when no one is looking

Offline DC

  • Member
  • Posts: 10,396
Re: Dipping tubes
« Reply #19 on: June 04, 2015, 10:11:26 pm »
The long ones penetrated a bit better but not much. The new targets let all of them stick in. My bow is about 35#. The new targets have a very strong skin and the wrapping behind the point would hang up on the it when I was removing the arrows. I turned a little notch in the arrow shaft so the thread would be flush with the surface. CA and sandpaper make it real smooth and the arrows come out one-handed. I'm a little concerned that the notch will compromise the shaft strength but there is still 2" of nail inside. So far so good.
Logged
Pages: 1 [2]
« previous next »