« previous next »
Pages: 1 [2]

Author Topic: wood deer grunt call on the lathe  (Read 16382 times)

0 Members and 1 Guest are viewing this topic.

Offline sleek

  • Member
  • Posts: 6,764
Re: wood deer grunt call on the lathe
« Reply #15 on: November 13, 2014, 11:14:42 am »
Awesome build, thanks. I dont have a lathe but I can chuck a block to my drill press to make a redneck lathe. Does it matter if you shape the outside before or after you drill your center holes, as far as the wood holding together on you?
Logged
Tread softly and carry a bent stick.

Dont seek your happiness through the approval of others

Offline tattoo dave

  • Member
  • Posts: 1,545
  • Rockford, MI
Re: wood deer grunt call on the lathe
« Reply #16 on: November 13, 2014, 06:58:12 pm »
Sleek, I suppose you could shape first. I drill first simply because its easier to do on the lathe. You may run into it breaking if you drill after. Also, if you drill after, and you want to thin it out more, that would be very difficult to do.

Also, you could drill a hole in just about anything  and make a call out of it. No lathe needed. ;)

Dave
Logged
Rockford, MI
Pages: 1 [2]
« previous next »