« previous next »
Pages: [1]

Author Topic: Board selection for Laminated Shafts  (Read 1865 times)

0 Members and 1 Guest are viewing this topic.

Offline ajbruggink

  • Member
  • Posts: 308
  • Aaron Bruggink, Oostburg, WI, USA
Board selection for Laminated Shafts
« on: September 07, 2014, 11:32:35 am »
Hey Guys,

I recently read 'How to Make Your Own Laminated Arrows' by Marc St. Louis in Primitive Archer Magazine volume 14 issue 1 and it makes me what to try my hand at making them but I have one question. If I were to make these from boards not timber, how picky do I have to be with the grain? Should the grain be strain the whole length of the board or does this lamination process make that no longer a concern?  Any replies are greatly appreciated.

Thanks,
Aaron
Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: Board selection for Laminated Shafts
« Reply #1 on: September 07, 2014, 01:05:12 pm »
Aaron, you should always pick the best stock with the straightest grain as possible. If you do use wood with runoffs they should be few and at a long angle with no swirls or knots. Allowing the wood to air dry and season will help with the stability of the shafts, laminated or not.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline ajbruggink

  • Member
  • Posts: 308
  • Aaron Bruggink, Oostburg, WI, USA
Re: Board selection for Laminated Shafts
« Reply #2 on: September 08, 2014, 11:45:28 am »
Thanks, Pat
Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: Board selection for Laminated Shafts
« Reply #3 on: September 08, 2014, 04:33:43 pm »
Contact Marc. I'm sure he will have more/better detail for you.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC
Pages: [1]
« previous next »