« previous next »
Pages: [1]

Author Topic: Question about finishes.  (Read 1734 times)

0 Members and 1 Guest are viewing this topic.

Offline skarhand

  • Member
  • Posts: 180
Question about finishes.
« on: January 01, 2014, 07:34:59 pm »
I have been messing around with different finishes, trying to fond one I like. Currently I am working on a 16x20x1.75 end grain cutting board made from rock maple and walnut for my wife's birthday. I am not sure what would be the best way to finish it. I started off by washing it down with acetone then need to pick a finish.

I was hoping to be ale to use something I already have, so any idea what would be best:

Formby's Tung Oil
Watco Danish Oil
Bullseye Shellac
Hunk of Bee's Wax

Any suggestions or advice would be greatly appreciated.

Joshua
Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: Question about finishes.
« Reply #1 on: January 02, 2014, 12:13:43 am »
Any of those will work as a finish.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline PEARL DRUMS

  • Member
  • Posts: 14,079
  • }}}--CK-->
Re: Question about finishes.
« Reply #2 on: January 02, 2014, 08:49:40 am »
Cutting boards need food grade sealer. Check out walnut oil or salad bowl finish.
Logged
Only when the last tree has died and the last river has been poisoned and the last fish has been caught will we realize we cannot eat money.

Offline Robby101

  • Member
  • Posts: 58
Re: Question about finishes.
« Reply #3 on: January 02, 2014, 12:45:26 pm »
Mineral oil or " John Boos Mystery Oil" work great on cutting boards.
Robby
Logged

Offline RBLusthaus

  • Member
  • Posts: 753
Re: Question about finishes.
« Reply #4 on: January 02, 2014, 12:45:59 pm »
mineral oil is the best food safe finish for cutting boards. 
Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: Question about finishes.
« Reply #5 on: January 02, 2014, 12:57:20 pm »
I guess I skipped over the cutting board part.  :-[   You need food grade finish for that.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline bubby

  • Member
  • Posts: 11,054
Re: Question about finishes.
« Reply #6 on: January 02, 2014, 02:14:59 pm »
A mix of need wax and mi.eral oil is a good safe finish used on wood, soften the wax and mix in the oil till it is a workable consistency, run it in and do several coats
Logged
failure is an option, everyone fails, it's how you handle it that matters.
The few the proud the 27🏹
Pages: [1]
« previous next »