« previous next »
Pages: 1 [2]

Author Topic: making a board bow with thickness planer?  (Read 7692 times)

0 Members and 1 Guest are viewing this topic.

Offline Thesquirrelslinger

  • Member
  • Posts: 1,245
Re: making a board bow with thickness planer?
« Reply #15 on: May 06, 2013, 02:39:15 am »
Wow, I only get to shoot about 2 times a week. For like an hour.
I like warbows, but there is no way on earth I can draw one.
Logged
"Insanity is doing the same thing over and over again and expecting different results"

Offline fisher2

  • Member
  • Posts: 48
Re: making a board bow with thickness planer?
« Reply #16 on: May 08, 2013, 01:33:15 am »
i shoot for form at 5 yards every day and once a week i shoot at 10-40 yards still focused on form
Logged

mikekeswick

  • Guest
Re: making a board bow with thickness planer?
« Reply #17 on: May 08, 2013, 07:59:20 am »
Board bows aren't quite as simple as people think!
Planer thicknessers do not leave a very good surface for gluing. They are rippled and hard. Use one to get close but then you need to make sure it's properley flat before gluing. Thick glass and sandpaper will work to flatten the surfaces and make them more accepting of glue but a drum sander is the correct machine if you want to go down that route.
Logged

Offline fisher2

  • Member
  • Posts: 48
Re: making a board bow with thickness planer?
« Reply #18 on: May 08, 2013, 11:00:56 am »
yeah i'd be using the planer to get 1/8" away or so then use the sander to finish it off
Logged
Pages: 1 [2]
« previous next »