« previous next »
Pages: 1 [2]

Author Topic: ash & osage  (Read 3359 times)

0 Members and 1 Guest are viewing this topic.

Offline 4est Trekker

  • Member
  • Posts: 311
Re: ash & osage
« Reply #15 on: February 04, 2013, 03:36:40 pm »
Nice work, bubby!  Looking forward to seeing how this one shapes up.

Darwin:  a properly glued joint (i.e. proper glue selection/preparation, surface preparation, and total surface area) will result in a glue joint that is stronger than the wood around it.  If done correctly, the wood around the joint will break before the joint itself.  There looks to be a good 6"-8" linear inches of glued surface in each splice...that equate to one strong bond.
Logged
"Walk softly, and carry a bent stick."

"And whatever you do, whether in word or deed, do it all in the name of the Lord Jesus Christ, giving thanks to God the Father through him."  Col. 3:17

Offline darwin

  • Member
  • Posts: 232
Re: ash & osage
« Reply #16 on: February 04, 2013, 04:03:37 pm »
Even if the bow was say 60#?
Logged

Offline bubby

  • Member
  • Posts: 11,054
Re: ash & osage
« Reply #17 on: February 04, 2013, 04:41:35 pm »
Darwin check out gstoneberg's mesquite & osage bow
Logged
failure is an option, everyone fails, it's how you handle it that matters.
The few the proud the 27🏹

Offline bubby

  • Member
  • Posts: 11,054
Re: ash & osage
« Reply #18 on: February 04, 2013, 04:44:59 pm »
thank's 4est for explain'n it better than I would
o.k. pearlie, back to the tablesaw it is
kip as far as the splice in the working part of the limb, i'm not smart enough to think it wont work :laugh:
Logged
failure is an option, everyone fails, it's how you handle it that matters.
The few the proud the 27🏹
Pages: 1 [2]
« previous next »