« previous next »
Pages: [1]

Author Topic: steel or copper rivets  (Read 1964 times)

0 Members and 1 Guest are viewing this topic.

Offline kid bow

  • Member
  • Posts: 434
steel or copper rivets
« on: December 17, 2012, 09:03:54 pm »
ok so the bow that i need to splice is ready. i found another alternative though. i need little steel rods or round peices of steel or copper. or a TBB called them rivets. its my only hunting bow and im trying to save it if anyone could spare these i would be grateful
« Last Edit: December 17, 2012, 09:06:59 pm by jonah214 »
Logged
i need nothing but my old bow and arrows.

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: steel or copper rivets
« Reply #1 on: December 17, 2012, 09:21:07 pm »
Splicing would be more durable than adding rivets. I believe they would weaken the bow.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline kid bow

  • Member
  • Posts: 434
Re: steel or copper rivets
« Reply #2 on: December 17, 2012, 10:08:18 pm »
i havent got any glue to splice with. the bows weight projects at 80lbs so im ok if it goes down.
Logged
i need nothing but my old bow and arrows.

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: steel or copper rivets
« Reply #3 on: December 18, 2012, 12:39:46 am »
TBIII will work and if you need back up wrap the handle with cordage and set it in glue.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline adb

  • Member
  • Posts: 5,339
Re: steel or copper rivets
« Reply #4 on: December 18, 2012, 10:39:03 am »
A small bottle of TB3 is less than $5.
Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: steel or copper rivets
« Reply #5 on: December 18, 2012, 10:56:03 am »
If you are insistant on rivets find some heavy copper electrical ground wire and make your own rivets...but a spliced handle would be more practical and durable.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline madcrow

  • Member
  • Posts: 1,531
  • Swift, Silent, and covered in wood shavings.
Re: steel or copper rivets
« Reply #6 on: December 18, 2012, 09:23:46 pm »
A couple of old broke drill bits will work in a pinch.  I did it once to reinforce the splice, but found out it wasn't needed as long as the glue joint was good.
Logged
Pages: [1]
« previous next »