« previous next »
Pages: [1]

Author Topic: Parallel vs Tapered?  (Read 1864 times)

0 Members and 1 Guest are viewing this topic.

Offline stringstretcher

  • Member
  • Posts: 1,557
    • Traditionalarcherycommunitysite.com
Parallel vs Tapered?
« on: March 17, 2012, 01:52:49 pm »
Here is a question for you arrow smiths that I would like an answer too. We all know how to measure spine of a parallel wood shaft. How is the spine measured and from what part of the wood shaft on a nock end tapered wood shaft? Let's just say a 14" taper? And would a full length tapered shaft be measured the same way as a parallel?
Logged

Offline Fred Arnold

  • Member
  • Posts: 1,566
  • From up on Munson Creek
Re: Parallel vs Tapered?
« Reply #1 on: March 17, 2012, 11:01:24 pm »
I'm not an arrow smith but find with my barrel tapered I need to go 5# heavier spine than with parallel. Spine is still measured from the stiff side center of the shaft. The barrel are tapered 10" from each end 23/64 to 5/16. If you like high FOC then taper the nock end only.
Logged
I found many years ago that it is much easier and more rewarding working with those that don't know anything than those that know it all.

Offline RBLusthaus

  • Member
  • Posts: 753
Re: Parallel vs Tapered?
« Reply #2 on: March 19, 2012, 08:31:26 pm »
Spine is still measured the same way - 2 pounds at 26 or 28 inches. 

That said, I usually spine mine prior to tapering - and then never go back and re-spine them.  My way may not be yours. 

Russ
Logged

Offline George Tsoukalas

  • Member
  • Posts: 9,425
    • Traditional and Primitive Archers
Re: Parallel vs Tapered?
« Reply #3 on: March 20, 2012, 07:07:52 pm »
A spine tester has 26" supports but the results are extrapolated to 28". Jawge
Logged
Set Happens!
If you ain't breakin' you ain't makin!
Pages: [1]
« previous next »