« previous next »
Pages: [1]

Author Topic: removing hop hornbeam bark  (Read 3394 times)

0 Members and 1 Guest are viewing this topic.

Offline carpentertimw

  • Member
  • Posts: 42
removing hop hornbeam bark
« on: March 08, 2012, 11:18:04 am »
does anybody have a good way to remove bark from dried hop hornbeam? somebody gave me some dried hop hornbeam and the bark is very resistant to coming off.
Logged

Offline PEARL DRUMS

  • Member
  • Posts: 14,079
  • }}}--CK-->
Re: removing hop hornbeam bark
« Reply #1 on: March 08, 2012, 11:18:27 am »
Drawknife
Logged
Only when the last tree has died and the last river has been poisoned and the last fish has been caught will we realize we cannot eat money.

Offline Pappy

  • Global Moderator
  • Member
  • Posts: 32,204
  • if you have to ask you wouldn't understand ,Tenn.
Re: removing hop hornbeam bark
« Reply #2 on: March 08, 2012, 11:23:11 am »
You can usually get it started on one end and peel it off,be careful because it has lots of ripples in the back,not to cut into the wood that will be the back. :) If you try and just draw knife the back you can very easily violate the growth rings.  :)
   Pappy
Logged
Clarksville,Tennessee
TwinOaks Bowhunters
Life is Good

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: removing hop hornbeam bark
« Reply #3 on: March 08, 2012, 11:32:40 am »
The HHB stave I made my trade bow from had been cut 5 or 6 years before and the bark was still on. I don't know what time of year it was cut but I used a drawknife to remove the bark. Just take it slow and easy.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline PatM

  • Member
  • Posts: 6,737
Re: removing hop hornbeam bark
« Reply #4 on: March 08, 2012, 12:14:18 pm »
He likely means getting all the bark off, not just the outer layer. No man can drawknife a
HHB stave and get all the bark off with a drawknife.
 The best way to get it clean is take most of the inner bark off and then soak the last bit of inner bark and use a spoon tip to push it off and get all the grooves clean.
 Some people have luck with the bark popping off as they start bending the bow but that depends on a lot of factors if you think it might ALL pop off.
Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: removing hop hornbeam bark
« Reply #5 on: March 08, 2012, 02:42:18 pm »
If the wood was harvested during ther growing season the bark should peel right off. If cut during the dormant season you will have to work to get it off.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline osage outlaw

  • Member
  • Posts: 11,962
Re: removing hop hornbeam bark
« Reply #6 on: March 08, 2012, 03:27:12 pm »
It's been a while, but I think I started with the drawknife and then used a scraper.  I used the point of a scissor scraper to get in the grooves.  I remember I had to wear safety glasses when I used the scraper because it would flip up tiny slivers of the bark into my face.
Logged
I started out with nothin' and I still got most of it left

Offline druid

  • Member
  • Posts: 475
Re: removing hop hornbeam bark
« Reply #7 on: March 08, 2012, 04:16:24 pm »
In my country, when you cut hornbeam its bark could be removed by fingers. After that (especially when it dries out) it is almost impossible to debark it fully.  :(
Logged

Offline Ifrit617

  • Member
  • Posts: 1,596
Re: removing hop hornbeam bark
« Reply #8 on: March 08, 2012, 04:32:42 pm »
I have use a drawknife on mine just go real slow...

Jon
Logged

Offline DRon knife

  • Member
  • Posts: 202
Re: removing hop hornbeam bark
« Reply #9 on: March 08, 2012, 05:25:27 pm »
I posted a method,but removed it.

Put it in a hot shower for a while(5-15 min),wrap it totally in painters plastic and put it in a hot room,car or furnace room for the day,unwrap a few inches and peel and scrape with a sharp knife. Ron
Logged
Pages: [1]
« previous next »