« previous next »
Pages: [1]

Author Topic: Help Please  (Read 1482 times)

0 Members and 1 Guest are viewing this topic.

Offline bowman_137

  • Member
  • Posts: 17
Help Please
« on: December 02, 2011, 02:14:46 pm »
I am brand new to bow making and i need a few Questions answered Im open to any and all advice. I started an oak board bow a couple months back it's 60" long a 1 1/8 at the handle and tapers to an inch at the tips. its 3/4 of an inch thick at the handle and tapers to 5/8" at the tips. Do i need to taper it more or sould it be fine the way it is??? Also what brace height sould I be looking for on a bow like this??? :-\
Logged
CAUTION!!!! SLOW LEARNER!!!!

Offline George Tsoukalas

  • Member
  • Posts: 9,425
    • Traditional and Primitive Archers
Re: Help Please
« Reply #1 on: December 02, 2011, 03:05:41 pm »
You can eventually take some wood off the last 8 or so inches . Is that your question?
There's info on my site. Jawge
http://georgeandjoni.home.comcast.net/~georgeandjoni/
Logged
Set Happens!
If you ain't breakin' you ain't makin!

Offline dragonman

  • Member
  • Posts: 1,142
    • virabows.co.uk
Re: Help Please
« Reply #2 on: December 02, 2011, 03:09:39 pm »
you can taper the tips (widthways) down to 1/2".... and I would brace it between 51/2"-6", not more than 6", hope thats a help...
Logged
'expansion and compression'.. the secret of life is to balance these two opposing forces.......

Offline bowman_137

  • Member
  • Posts: 17
Re: Help Please
« Reply #3 on: December 02, 2011, 03:19:45 pm »
Ok thanks that was my Q. it just seems a little thick to me but i don't know much. Good site George it is very informative
Logged
CAUTION!!!! SLOW LEARNER!!!!
Pages: [1]
« previous next »