Author Topic: Brace Height Of Primitive Bows?  (Read 21267 times)

0 Members and 1 Guest are viewing this topic.

Offline NOMADIC PIRATE

  • Member
  • Posts: 1,910
Re: Brace Height Of Primitive Bows?
« Reply #15 on: June 15, 2007, 09:25:45 pm »
5 1/2" is pretty much standard for all my bows, little tweeking now and again, but not by much
NORTH SHORE, HAWAII

brokennock

  • Guest
Re: Brace Height Of Primitive Bows?
« Reply #16 on: June 16, 2007, 02:29:55 am »
I like anywhere between 4.5" to 5.75" depending on length of bow and side profile unbraced.
 As for arrow spine, I would start 10 lbs. under the draw weight at my draw length, leave em long and cut them back slowly till they shoot good with a 125 grn head. then if I'm planing to use a heavier hunting point I check them for flight with those and tweek brace height and nock point to try and get it right from there.

Offline jpitts

  • Member
  • Posts: 313
Re: Brace Height Of Primitive Bows?
« Reply #17 on: June 16, 2007, 11:53:13 am »
Ok...Bob brought up something that I'm curious about. Which is the "standard" or is the most accepted way to measure brace height? Thumb extended fist from belly side of bow? or from the back of the bow?
Jimmy / Dallas, Georgia

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: Brace Height Of Primitive Bows?
« Reply #18 on: June 16, 2007, 01:59:25 pm »
The way I measure brace height is with my fistmele, heal of my fist on the belly(at the handle) with my thumb extended up. The actual brace height is measured from the string to the back of the bow, at the handle. My fistmele is just my indicator of where brace should be and not the actual measured brace height.  ??? ::) ;D     Pat
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline Justin Snyder

  • Administrator
  • Member
  • Posts: 13,794
Re: Brace Height Of Primitive Bows?
« Reply #19 on: June 16, 2007, 02:10:23 pm »
The fist just happens to be a tool you usually have with you, right Pat.  ;D  I put my hand on the belly of the handle.  I don't actually measure to the top of my thumb.  I go to the last joint of my thumb or just past.  I determined this by finding a brace height I liked without measuring. Then measuring it with my fist.  I just try to reproduce the same height, using my hand as a guide.  Justin
Everything happens for a reason, sometimes the reason is you made a bad decision.


SW Utah

Offline jpitts

  • Member
  • Posts: 313
Re: Brace Height Of Primitive Bows?
« Reply #20 on: June 16, 2007, 02:29:43 pm »
ok so the measurement is taken from the back of the bow and not the belly side at the base of the fist.....
If thats the case I've been doing it wrong the whole time.......cause that add's at least an inch or two  to the measurement.
Jimmy / Dallas, Georgia

Offline Justin Snyder

  • Administrator
  • Member
  • Posts: 13,794
Re: Brace Height Of Primitive Bows?
« Reply #21 on: June 16, 2007, 03:16:56 pm »
That may be the "traditional" way to do it. That don't mean your way is wrong.  Like I said, I found a brace height that I like and found a way to consistently reproduce it.  If you are happy with the low brace height you have don't change it. Lower brace means more of the energy from the bow is put into the arrow.  Besides, if I use my fist on the back of the bow, it may be the same as someone else using their fist on the belly.  It is more important to twist the string and find the height you need than to do it like any tradition says. It also may need to be adjusted for different bows.  Justin
Everything happens for a reason, sometimes the reason is you made a bad decision.


SW Utah

Offline NOMADIC PIRATE

  • Member
  • Posts: 1,910
Re: Brace Height Of Primitive Bows?
« Reply #22 on: June 16, 2007, 10:20:02 pm »
As a matter of fact jpitts, I belive if there has to be a standard way to mesure brace should be from the back of the bow, nowadays there's up to 1 1/2" difference with all the styles of handles, this current method was carryed over from "Hunting with the bow and arrow", therefore the ELB wich had no handle
NORTH SHORE, HAWAII

Offline GregB

  • Member
  • Posts: 4,079
  • Greg Bagwell
Re: Brace Height Of Primitive Bows?
« Reply #23 on: June 17, 2007, 12:02:05 pm »

I use my fistmele also...if you'll bring the bow by my house, I'll be happy to set it for you! ;D
Greg

A rich person can be poor monetarily, the best things in life are free...

Offline Badger

  • Member
  • Posts: 8,124
Re: Brace Height Of Primitive Bows?
« Reply #24 on: June 17, 2007, 12:16:59 pm »
The main thing I pay attention to is that my 5" feathers clear the handle when I nock up. Some bows like higher brace heights a well, Bow with a lot of deflex as you might see in recurves or some r/d bow seem to handle better with higher brace heights of 6' or better sometimes. Steve

Offline jpitts

  • Member
  • Posts: 313
Re: Brace Height Of Primitive Bows?
« Reply #25 on: June 17, 2007, 10:23:25 pm »
Thanks for the offer GregB, I think I'll do like I've always done. I'll bring it up till my feathers barely clear the shelf  ;D
Thanks Northshore....I can see them using the back for measurement in Merry Olde England...
Jimmy / Dallas, Georgia

Offline gpw

  • Member
  • Posts: 149
Re: Brace Height Of Primitive Bows?
« Reply #26 on: June 19, 2007, 11:02:00 am »
Gosh ... I'm kinda' LARGE , my fistmele is 7"  But I'm shooting 66"-72' longbows of hickory backed red cedar...with a 29-30"  DRAW LENGTH...   Made 64 bows now ,all kinds , mostly selfbows... 23 broke , about 5 shoot really well, the rest are OK , learned alot , especially how a too low brace height leaves a nasty ,painfull bruises on your inner forearm ... ;D   If the bow is the correct length for your draw, and tillered correctly , it should survive a comfortable brace height...and shoot better /more accurately to boot .

Offline Justin Snyder

  • Administrator
  • Member
  • Posts: 13,794
Re: Brace Height Of Primitive Bows?
« Reply #27 on: June 19, 2007, 11:06:38 am »
GPW my fistmele is about 7" also.  That is why I mentioned going to the last joint in my thumb, not the end.  ;D Justin
Everything happens for a reason, sometimes the reason is you made a bad decision.


SW Utah

Offline gpw

  • Member
  • Posts: 149
Re: Brace Height Of Primitive Bows?
« Reply #28 on: June 19, 2007, 11:26:53 am »
No reason to get too specific , we find every bow has it's own favorite brace height, when it shoots the best ...  experiment, besides it's always FUN to shoot alot of arrows anyway ...  if it breaks , it ain't worth having ... certainly not in the woods...